Holzmann FS 160L, User Manual

Page: 10 / 49

www.holzmann-maschinen.at
IMPORTANT
!
Shut the machine off with the red but-
ton of the main switch and wait until
the spindle rotation has stopped entire-
ly before performing any adjustments
or setups.
For some setups you need to unplug the
machine additionally to avoid the dan-
ger of unintentional machine start up.
ENGLISH
4. OPERATION
SPINDLE HEIGHT ADJUSTMENT
See Fig. D:
Set the height of the moulding spindle by
means of the hand wheel located on the
rear right side of the stand and secure it
with the arresting screw.
One full turn is 2mm.
SPINDLE SPEED CHANGE
See. Fig. E:
To change the spindle speed, loosen the
lock handle (A) and pivot the motor as-
sembly towards the spindle. Reposition
the belt to the desired speed and tension
the knob(B) back again.
INSTALL CUTTER TOOLS
See Fig. F:
Only use moulding cutter tools that are
designed for manual feeding and may
be clamped firmly and safely. Only tools
conforming to EN847-1:2005 and marked
shall be used.
Before mounting tool (A) make sure that
spacing rings (E) are clean and not dam-
aged. Make sure that the fastening meth-
od is proper. The moulding tool is fixed
and clamped by bolt (nut) (C), through
spindle ring (D) and spacing rings (E) on
the moulding spindle!
Adjust the hole in the table according to
the diameter of moulding tool (A) by table
rings (B).
When installing the moulding tools, the
cover of guard needs to be opened. Loose
the two locking knobs to open the cover.
After installation, close the cover and lock
it through the locking knobs.
Warning: Always close the cover of guard
and lock it securely after tools are in-
stalled.
Always install the cutter tools as low as
possible!
Make it a habit to check immediately after
cutter tool installation the free run of the
cutter tool. Turn it by hand, it shall not
touch the fence or hooding at any time.
FENCE ADJUSTMENT
The fence is a two-piece adjusting system.
Each fence is independently adjustable to
compensate for different cutting thick-
nesses and special milling applications.
If you remove the entire edge of a work-
piece you should not position the two
fences in line, but position the outgoing
fence by that mm more in front the cutter
tools cut away from the workpiece.
INSTALL ROUTER COLLET SPINDLE
Remove original spindle by fixing spind-
le and loosening the spindle nut. Install
the router collet spindle. Loosen spindle
again!
OPERATION ADVICES
>> Before starting the machine up,
check distance between tool and
table as well as fence. Check all
tightening levers and knobs being
tightened properly.
>> Turn the machine on by pressing
the green button 4 (See Fig. A).
>> Beware of material kickback! To
prevent the material to kick
upwards, you should adjust the
guide rail to workpiece
max. 5mm.
5. MAINTENANCE
>> Visual check of machine, machine
parts, power cable, cutting tools
for any damage.
Clean the machine regularly after every
operation! Clean especially the table, the
fence faces and the mitre gauge.
Do not clean wood chips etc. by hand but
rather use a suitable brush tool and/or
pressure air.
WARNING
!
Always switch off the motor and discon-
nect the plug from the power supply pri-
or to any maintenance, upkeep, checks
or cleaning.