TROUBLESHOOTING
54
BB810SMART-G
TROUBLESHOOTING
If you are unable to carry out the necessary repairs properly and/or do not have the required
training, always consult a specialist to solve the problem.
Problem
Possible cause
Remediation
Producing wavy cuts
1. Inadequate blade tension.
2. Improper blade guide set up.
3. Improper blade tracking.
4. Sap build up on blade.
5. Dull blade.
6. Pushing mill too quickly.
1. Tighten blade
2. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new blade and ensure to run
always with blade lubrication.
5. Install new blade.
6. Slow feed rate down and push head
slower through log.
Last board is tapered or
narrow in the middle.
Tracks are not levelled.
Level the tracks
Blade comes off of band
wheels
1. Inadequate blade tension.
2. Improper blade guide set up.
3. Improper blade tracking.
4. Belts are worn.
5. Dull blade.
6. Pushing mill too quickly.
1. Tighten blade
2. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new belts.
5. Install new blade.
6. Slow feed rate down and push head
slower through log.
Blades are breaking.
1. Too many blade sharpening’s.
2. Inadequate blade tension.
3. Improper blade guide set up.
4. Improper blade tracking.
5. Pushing mill too quickly.
1. Install new blade
2. Adjust blade tension
3. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new belts.
5. Slow feed rate down and push head
slower through log.
Blade is slowing down or
stopping when milling
1. Inadequate blade tension.
2. Improper drive belt tension.
3. Pushing mill too quickly.
1. Tighten blade
2. Adjust V-Belt tension
3. Slow feed rate down and push head
slower through log
Mill is not cutting/cutting
very
slowly.
1. Dull blade.
2. Blade-teeth are backwards.
1. Install new blade
2. Assemble blade correct
Mill is vibrating excessively. 1. Log is not clamped securely.
2. Belts are deformed.
3. Bandwheel bearing issue.
4. Pushing mill too quickly.
5. Loose bolts.
1. Ensure log is clamped firmly resting on
log bunks and against log supports.
2. Install new Belts
3. Install new band wheel bearings
4. Slow feed rate down when milling.
5. Check all bolts to ensure they are tight.
Engine doesn’t start
1. too less engine oil quantity
2. no/too less fuel
3. emergency stop switch pressed
(not on start)
4. open safety-guard (blade cover-
microsswitch)
1. check/refill engine oil
2. check/refill fuel
3. unlocking emergency stop switch
4. Close and tighten safety-guard
Engine stops after a short
time
1. choke in position "closed
2. fuel tap closed
1. choke in position "open
2. open fuel tap
Summary of Contents for BBS810SMART-G
Page 79: ...ZUBEHÖR ACCESSORIES HOLZMANN Maschinen GmbH www holzmann maschinen at 79 BB810SMART G ...
Page 80: ...ZUBEHÖR ACCESSORIES HOLZMANN Maschinen GmbH www holzmann maschinen at 80 BB810SMART G ...
Page 81: ...ZUBEHÖR ACCESSORIES HOLZMANN Maschinen GmbH www holzmann maschinen at 81 BB810SMART G ...
Page 82: ...ZUBEHÖR ACCESSORIES HOLZMANN Maschinen GmbH www holzmann maschinen at 82 BB810SMART G ...
