HOLZMANN MASCHINEN BBS810SMART-G, User Manual

Page: 45 / 86

ASSEMBLY
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
45
BB810SMART-G
14. Appling cable connection
(emergency stop, micro switch saw
blade guard)
One of the two yellow ground plug
connections on the engine must
be disconnected. (1. low oil level
sensor, 2. Engine-ON/OFF-switch)
and the two plug connections V1
and V2 as shown in the picture and
the two ground connections are
made by clamping on the screw. K1
is the cable connection to the
micro switch, K2 is the cable
connection to the emergency stop
switch on the pull/push handle.
NOTICE: After connection check if
the engine is stopped by the
emergency stop switch and also
with the micro-switch (by opening
the guard). If not please check the
wiring.
14.3 Checklist before starting up
NOTICE
The use of paint thinners, gasoline, aggressive chemicals or scouring agents leads
to material damage to the surfaces! For cleaning, therefore, only use mild cleaning
agents!
•
Clean the machine and if necessary remove dirt and dust.
•
If the air filter is dirty, blow through the filter cartridge from the inside by moving a jet of
dry compressed air up and down. Continue to do this until all dust is removed. If
necessary, replace the air filter by a new one.
• Check the carburettor for external dirt and dust and clean it with dry compressed air if
necessary.
•
Check lock nuts, screws and bolts for tightness. (Screws or bolts that have been loosened
by vibration can lead to accidents!)
•
Check motor-oil level.
Checking the engine oil level
WARNING
ATTENTION! For transport motor oil has been drained. Fill up with 4-stroke quality
motor oil before first operation! Failure to do so will result in permanent motor
damage and void guarantee!
NOTICE
A too low oil level will cause damage to the engine and shorten the service life of the
machine. Therefore, check the motor oil level before every start and if necessary fill
up with oil.