Care, maintenance and repair
TKS-Z 400 | Version 1.01
17
9.3 Lift cutting
Step 1: Adjust the saw blade by adjusting the lifting
handle (A) below the work table.
Step 2: Place the piece of wood on the table and against
the rip fence, move the piece of wood over the
saw blade and lock the rip fence by turning the
handle (B).
Fig. 23: Lift cutting
Step 3: Start the machine and raise the handle (A) to cut
the piece of wood.
Step 4: Switch off the machine if no further cutting is to
take place immediately afterwards.
9.4 Cutting chamfers
Step 1: Loosen the locking screw (A), press the saw
blade box and tilt it 45 degrees. Tighten the
locking screw to secure the saw blade box.
Fig. 24: Cutting chamfers
Step 2: Perform the cut according to the above instructi
-
ons.
Step 3: Switch off the machine if no further cutting is to
take place immediately afterwards.
Fig. 25: Turn the rip fence
9.5 Make a miter cut
Step 1: Loosen the locking screw (A) under the work ta
-
ble and turn the table to the desired degree.
Then tighten the locking screw.
Fig. 26: Make a miter cut
Step 3: Start the machine and perform the cut.
Step 4: Switch off the machine if no further cutting is to
take place immediately afterwards.
10 Care, maintenance and repair
NOTE!
When slitting, the width of the piece of wood is less
than 120mm, please turn the rip fence to use the bot
-
tom to guide the workpiece.
DANGER!
Risk of death due to electric shock!
Contact with live components may cause mortal dan
-
ger. Switched on electrical components can cause
uncontrolled movements and lead to serious injuries.
- Before starting cleaning and maintenance work,
switch off the machine and disconnect the mains
plug.
- Connections and repairs to the electrical equipment
may only be carried out by a qualified electrician.
Lower side
Table