Setting up and connecting
TKS-Z 400 | Version 1.01
11
8.2 Set up the Circular saw
Check the state of the table saw immediately upon
receipt and immediately claim any damage from the last
carrier, even if the packaging is not damaged. In order to
secure claims against the carrier, we recommend that
you leave your machinery, equipment and packaging
materials in the condition in which you found them when
the damage was discovered. We kindly ask you to inform
us of any other complaint within six days after receipt of
the delivery.
Required tools:
• 1 Wrench 17 mm
• 1 Wrench 8 mm
• 1 Wrench 12mm
• 1 Wrench 10mm
• 1 Wrench 15 mm
• 1 Wrench 19 mm
The machine is mostly delivered assembled. Before
use, the following parts must be mounted or adju
-
sted:
blade guard
Step 1: Pass the end of the blade guard Insert the retai
-
ning clip (A) into the underside of the table (B)
and lock it by tightening the screw
(M10x25mm) to ensure the stability of the en
-
tire blade guard.
Fig. 9: Mounting the saw blade guard
Step 2: Connect the saw blade guard and the saw blade
guard bracket as shown in step 1 and step 2 in
Fig. 10.
Fig. 10: Assembly of the retaining clip
CAUTION!
Risk of injury due to a machine that is not stably er
-
ected! Check the stability of the machine after placing
it on stable ground.
ATTENTION!
Some metal parts can be sharp-edged. Check all me
-
tal parts to avoid injury.
ATTENTION!
Pay attention to the weight of the machine!
The machine may only be set up by two persons.
Check the aid accordingly for sufficient dimensioning
and load capacity.
DANGER!
To ensure sufficient stability of the machine, it should
be screwed to the ground.
DANGER!
- Read each step before executing it.
- Take care of the corresponding parts for each work
step.
Step 2 Step 1