12
TKS-Z 400 | Version 1.01
Setting up and connecting
Assembly of the wheels
Step 1: Mount the transport wheels on the two adjustable
feet using the 4 screws (M8x80mm).
Fig. 11: Assembly of the wheels
Assembly of the rip fence
Step 1: Place the carrier (A) on the sliding table and at
-
tach the rip fence (B) to the carrier, but do not
tighten the screws (C) that secure the rip
fence.
Fig. 12: Assembly of the rip fence
Step 2: Loosen the locking screws (D) and adjust the
stop guide so that it runs parallel to the edge of
the worktable. Hold the sliding table and
worktable at the same height and tighten the
locking screws (D).
Step 3: Measure the distance between rip fence and
main knife, set the rip fence slightly to make
sure L1 = L2, and then tighten the locking
screws (C).
Fig. 13: Checking the rip fence
Assembly of material supply and material removal
Please assemble the material supply and material
discharge according to the exploded view on page 22.
8.3 Settings
Set miter cutting angle
Step 1: Release the star grip (A) under the table. Now
turn the table until the pointer "0 °" with the
pointer on the mounting matches.
Step 2: Fix the bolt (B) against the lock plate (C) under
the table and lock it.
Step 3: Turn the table and align the 90 degree angle with
the pointer on the mounting table.
Step 4: Mount another screw (B) against the locking
plate (C) under the table.
Step 5: When you want to set the table to the desired
cutting angle, tighten the locking knob.
Fig. 14: Set miter cutting angle
NOTE!
Before each adjustment make sure that the machine
has been disconnected from the mains.
Table