Connecting the Inlet Hose
Drain Hose
For Customer Services, Spare Parts &
Manufacturer’s Guarantee Information please call
01204 664 084
-9-
1. Connect the inlet hose to the connector on the
water inlet valve on the back of the appliance
–
see fig 2.0
2. Apply the other end of the inlet hose to a tap
runs cold, fresh water
– see fig 2.1.
Note:
The hose supplied this this appliance
should be used. Do not reuse an old inlet hose.
1. Use the drain hose bracket supplied, to keep
the end of the drain hose secured in the
outflow pipe
– see fig 3.0. Do not extend the
length of the drain hose
– if a longer hose is
required contact the customer service number
below.
2. The height of the drainage outlet must be 80-
100cm
– see fig 3.1. Fix the drain hose to the
clip at the back of the washing machine to
prevent it from dropping off.
Note:
The drain hose should not be submerged in
water and should be securely fixed and leak free.
If the drain hose is placed on the ground or if the
pipe is at a height of less than 80cm, the washing
machine will continuously drain while being filled
(self-siphoning).
Connecting to the power supply
Before connecting to the power supply, check the following:
-
The socket it adequate for the maximum power of the washing machine.
-
Fuses in the circuit should be rated for no less than 15a.
-
The voltage should meet the requirement.
-
The power outlet should be correct for the washing machine plug.
-
Connect the machine to an earthed socket outlet.
Fig 2.0
Fig 2.1
Fig 3.0
Fig 3.1
