Holmatro PCT50, Manual

Page: 44 / 195

EN
44 916.400.139_002 PCT50
• Short-circuit
• Over temperature
3.10 Accessories
3.10.1 Accessories Pentheon system
/i
3.10.2 Tool specific accessories
The table below shows the available accessories for each model with the corresponding part numbers.
/i
3.10.3 Pulling attachments and pull chain set
Pulling attachments make it possible to use a combi tool for pulling. The pulling attachments must be
put on the blades. The pulling attachments may only be used in combination with the corresponding pull
chain set. These pulling chains consist of two parts, each with a shortening hook that only grabs the
chain. The chains are 1.5 m and 3 m long respectively.
3.10.4 Installation of the pulling attachments
Refer to Fig. 8
•
Make sure that the blades are slightly open.
• Push (A) and pull (B) the lock pins out untill they lock.
• Remove the spreading tips from the blades (C).
Description model plug type
Battery pack PBPA287 151.000.583
Battery charger PBCH1 AC-EU 151.000.629
PBCH2 AC-US 151.000.742
PBCH3 DC worldwide 151.000.632
PBCH4 AC-JP 151.000.630
PBCH5 AC-UK 151.000.631
Mains connector PMC1 EU 151.000.633
PMC2 US 151.000.743
PMC4 JP 151.000.634
PMC5 UK 151.000.635
On-tool charge cable POTC1 worldwide 151.000.499
Daisy chain power cable DCPC1 worldwide 151.000.503
Description
Pulling attachments Set 150.182.078
Pulling chains Set 150.582.261
Set pulling attac spreading tips 150.182.365
WARNING
Hoisting is not permitted with these accessories.
The pulling accessories are intended solely for the horizontal movement of loads.
CAUTION
Check what the load is doing and make sure that it is always supported.
Make sure that the tool can move freely during pulling and always remains in a straight line
between both pulling attachments.