EN
18
916.000.186_004
C** #U
2.2
Test code (Fig. 1)
All pictograms attached to the equipment pertaining to safety and danger must be complied with and
remain clearly legible.
/i
2.3
General safety regulations
•
Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
•
Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
•
Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Except for electrical
parts, rinse parts that have come into contact with corrosive acid or liquid with a lot of water. Consult
your Holmatro dealer for a resistance list.
•
Prevent dirt in and on the couplers.
•
Protect equipment against sparks during welding or grinding activities.
•
Avoid an unhealthy posture while working. It can result in physical complaints.
•
Follow the inspection and maintenance instructions.
•
Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
•
Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.4
Personal safety
Personnel that uses or assists in the use of the equipment must wear all personal means of protection
as prescribed in the standard work procedure. Negligent use of personal means of protection can result
in serious injury. During use wear at least the following personal means of protection:
•
Helmet;
•
Safety goggles or full face shield;
•
Safety gloves;
•
Safety clothing for the entire body;
•
Safety shoes with good ankle support and toe protection.
2.5
Safety regulations with respect to the equipment
2.5.1
General
•
Position the pump with the hose connected during use at a safe distance of at least 1 metre from
buildings and constructions.
2.5.2
Hose
•
Do not allow heavy objects to fall on the hose.
•
Keep the hose away from the working area of the tool.
•
Prevent damage to the hose.
•
Avoid kinks in the hose; never bend the hose past its minimum bending radius (75 mm).
Type of mark
Position
Description
Test code
A
The first 4 digits of the test code specify the date of manufacture of the
hose (yymm*****). The test code is located on the pressure sleeve of
the male coupler and becomes visible when the bending restriction is
pushed off the pressure sleeve.
