INSTALLATION
All in one outdoor data collector , solar powered
•
Frequency: 917MHz
•
Transmission range: 100 meters in open area.
** Actual distance may be varied depending upon the environment, and can be
shortened by interference such as concrete walls.
•
Solar p built-in Rechargeable battery: 3.7V, 1800maH
Installation
•
Already fitted with Lithium Poly (LIPO) rechargeable battery.
•
Open the battery cover located at the back of the main unit and remove LIPO battery
and charge it with the charger supplied. This should not take longer than one hour.
•
Before closing the battery cover, push the inside black switch from OFF to ON (very
important) , and check if the red LED light is flashing when the switch is turned to ON,
this means the transmission is working. Then close the battery cover properly.
•
The red LED light will flash approximately every 1 minute when transmitting the signal
to the inside main unit.
The Indoor Receiver
•
The Indoor Receiver can be placed onto any flat surface or wall mounted at the desired
location by the hanging hole, It is important to check that the radio signal can be
received before mounting.
SWITCH