B U L L E T I N # 1 1 9 4 G L V - 4 0 D 1 G E A R L E S S T R A C T I O N M A C H I N E
Page 7-8
Rev. A - 04/01/2022
Brake Removal
1. Remove covers as necessary to access terminal blocks and brake pin set screw (4mm
hex key).
2. Disconnect machine power, see Figure 31.
3. On the machine side disconnect the Brake and Brake Switch wires for the brake that is
to be worked on, see Figure 32.
4. Use a wrench to loosen the mounting bolt of the installation bolt 1, so that the end face
of the guide screw sleeve of the guide screw 2 is separated from the mounting surface
of the base
.
5. Remove the brake and related connecting accessories.
6. New or repaired brakes are replaced in the reverse order of the above instructions.
Figure 32
Figure 31
REMOVE
CONTROLLER
POWER HERE
