BA_PH_546-100_EN_06-22.docx
45
13.2.2
Magnetic Quick Adjusters 1533 (Option)
The knives can be adjusted even faster, more precisely and
more comfortably with the two optionally available magnetic
quick adjusters 1533 (refer to section
16).
Before starting, make sure that the clamping surfaces of the
cutter block and the cutter wedges are clean. The planing
knives must always be sharpened, honed and balanced in par-
allel.
Then proceed as described below:
Figure 57: Magnetic quick adjusters 1533
•
Using a flat spanner SW17, loosen all screws (
8
) one after the
other and remove the blunt knives.
•
Place the two adjusters 1533 (Accessories
16.1.2) with the
magnetic shoes (
4
) onto the knife shaft body (not in the knife
area) and press the brass stop piece (
5
) with the adjusting nut
(
2
) down to the shaft body diameter.
•
Turning back the adjusting nut (
2
) gives the blade projection.
One graduation point (
3
) on the neck of the adjusting nut cor-
responds to 0.1 mm.
•
The blade projection on all thickness planers is 1.0 mm. The
adjusting nut (
2
) is to be turned back by 10 pitch points (
3
).
•
Then insert the new resp. sharpened knives (
1
), press them
into the knife holder of the cutter block with a piece of wood
and screw them slightly tight.
•
After adjustment, the adjusters are placed over the planing
knives according to
Figure 58 so that the spring-loaded pin
(
6
) rests against the cutter body (clamping screw side).
•
The knife can be pressed up to the brass stop piece by the
spring (
7
).
Figure 58: Adjustment of the cutter block
•
Then tighten the clamping wedge (
9
) from the centre outwards with the screws (
8
) and the adjustment is
finished. The adjusters must not be placed tilted or angled, otherwise the adjustment will be inaccurate.
•
After approx. 5 minutes of running, retighten the cutter block screws.
Maximum permissible knife projection over the shaft base body = 1 mm
The optimum tightening torque for the cutter block screws is 32 Nm.
Please do not use an extension or a hammer!
Suitable replacement knives and accessories for the traditional cutter block can be found in section
2
3
4
5
1
6
7
8
ø 80
mm
9