HOKUBEMA PANHANS 546|100, Operating Manual

Page: 39 / 55

BA_PH_546-100_EN_06-22.docx
39
11.4 Positioning Mode ( “ Machine ” Menu)
11.4.1 Table Height Positioning in Absolute Mode
After pressing “ Start ” , the height of the table is positioned directly to the value defined in the field “ Set ” .
Figure 38: Setpoint input in absolute mode Figure 39: Position reached in absolute mode
•
Absolute mode is active when the “ Inc ” button is visible in the bottom line of the screen and “ Abs ” appears
in the input fields in the top left-hand corner (see

Figure 38 and

Figure 39).
•
Tap on the field “ Set: ” and enter the desired setpoint, e.g. 100.00 mm (

Figure 38).
•
Press “ Start ” to start positioning:
→
The “ Set: ” field is highlighted in red until the setpoint value “ Act: ” is reached (see

Figure 38).
→
The “ Set: ” field changes to green as soon as the target position “ Act: ” is reached (see

Figure 39).
•
Press the “ Stop ” button if you want to cancel the positioning process.
By pressing “ Start ” again, you can continue the positioning at any time.
Note: When positioning to a setpoint > actual value, this is first overrun by approx. 1 mm and then approached
from below. This serves to compensate for spindle play (loop function).
11.4.2 Table Height Positioning in Incremental Mode
In this mode, positioning is incremental, resp. at each “ Start ” , the dimension entered in the “ Set: ” field is sub-
tracted from the current actual value. Thus the incremental value defines the depth of cut (max. 8 mm).
Figure 40: Setpoint input in incremental mode Figure 41: Setpoint reached
•
Press the “ Inc. ” button to change to incremental measurement mode.
•
Then tap on the "Set" field and enter the desired incremental setpoint, e.g. 3.00 mm (

Figure 40).
Note: Dimensions resp. chip removal > 8.00 mm are not possible (a short beep sounds).
•
Press “ Start ” to start positioning:
→
The “ Set: ” field is highlighted in red until the setpoint value “ Act: ” is reached (see

Figure 40).
→
The “ Set: ” field changes to green as soon as the target position “ Act: ” is reached (see

Figure 41).
→
With “ Start ” this process can now be repeated arbitrarily often.
•
Press the “ Stop ” button if you want to cancel the positioning process.
By pressing “ Start ” again, you can continue the positioning at any time.
•
To return to the absolute mode, press the button “ Abs ” .