BA_PH_546-100_EN_06-22.docx
33
10
Operation
All adjustment and operation work is only permitted when the cutter block is stopped!
10.1
Surface Planing & Jointing
10.1.1
Electrical Adjustment of the Infeed Table
•
The chip removal is set via button (
3
),
see
•
First move the selector switch (
28
) to the right inclined
position, see
•
Pressing the button (
3
) moves the feed table up or
down, depending on the direction of the arrow.
•
Arrow pointing upwards:
→
Chip thickness decreases
•
Arrow pointing downwards:
→
Chip thickness increases
Figure 21:
Operation “planing & jointing”
The chip removal is visualised on the digital indicator (
4
). The cutter block can be switched on and off via pres-
sure switch (
2
). Further information can be found in the section
10.1.2
Adjusting the Outfeed Table
In the standard model, the outfeed table is set exactly to the cutter flying circle at the
factory. This can only be adjusted by qualified personnel.
10.1.3
Adjustable Outfeed Table (Option)
At a central point, the optionally available adjustable outfeed
table for re-sharpenable planing knives is used to adjust the
delivery table to the cutter flying circle.
This option is recommended when re-sharpening the standard
Tersa cutter block or the optional 4-knives traditional cutter
block .
Procedure:
•
Loosen spindle clamp (
S
).
Figure 22: Outfeed table adjustment
•
Turn the handwheel (
H
) two turns counterclockwise
↺
to ensure
spindle play compensation
→
The outfeed table is lowered.
•
Turn the handwheel (
H
) clockwise
↻
and set the desired dimension.
→
The outfeed table is lifted.
•
Turn the handwheel (
H
) 1/3 turn counterclockwise again to reduce the preload.
•
Tighten the spindle clamp (
S
) again
→
9 graduations on the scale correspond to approx. 0.1 mm height adjustment of the outfeed table.
→
Recommendation: The table can be set even more accurately with a dial gauge with magnetic stand.
The article number of this option can be found in section
4
mm
3
2
H
S
