BA_PH_546-100_EN_06-22.docx
46
13.3
Changing the Knives on PANHANS Spiral Cutter Block (Option)
Figure 59: Spiral cutter carbide inserts
The optionally available PANHANS spiral cutter block consists
of 6 spiral-shaped rows of cutters, each segmented with 27
special 4-fold carbide inserts.
Only the PANHANS service set for spiral cutter shafts
1
(see
section
16.1.2) is to be used for turning or replacing the
cutting inserts.
The set includes a torque spanner for the M6 x 15 Torx screws,
which ensures the correct tightening torque for mounting the
cutting plates and thus optimal function.
13.3.1
Procedure for Changing the Knives
Changing or turning the cutting inserts is very simple:
•
Unscrew the Torx screws of the cutting insert and remove it from the socket.
•
Clean the insert holder with the accessories included in the set.
•
If the plate is to be turned over, clean it from all sides
(the plates are numbered for better orientation).
•
Now replace the cutting insert or turn it to the position of the next number.
Then tighten it with the torque spanner until it locks into place.
Only use the PANHANS service set for spiral cutter shafts to change and turn the cutting inserts.
The manufacturer is not liable for damage caused by a deviating or improper procedure!
13.3.2
Advantages of the PANHANS Spiral Cutter Block
1.
When using a spiral cutter block its
“
pulling cut
”
significantly improves the cutting quality and thus the plan-
ing result.
2.
Another advantage is the simplified knife replacement due to segmentation and reduced knife changing
times. In the case of minor damage or blunt spots, it is usually sufficient to simply turn or replace the cutting
inserts at the damaged spots. It is not necessary to replace the entire blade.
3.
A spiral cutter block produces much smaller chips and thus additionally protects the extraction unit.
4.
The use of a spiral cutter block ensures lower power consumption and also reduced noise emission.
1
Also included in the set are 1 litre of resin dissolving concentrate, one steel and one brass cleaning brush, 10
reversible cutting inserts (15 x 15 x 2.5 mm), 5 Torx screws (M 6 x 15) and two T20 bit inserts for the torque
spanner. The set is supplied in a practical storage case.
This and other accessories for your spiral cutter block can be found in section
