Hoft & Wessel HW 86012, Firmware Manual, Page: 90 / 141

CONFIGURATION COMMANDS
Configuration Commands Reference
90 2.10
•
19.01.2007
4.4.11.2 Firmware diagnostics: CRC
Syntax Command CRC
Response
<crc1>,<crc2>,<crc3>
Description Perform a self check of the firmware by computing a cyclic
redundancy checksum over the content of the Flash EPROM.
Return value(s) crc Computed 16 Bit cyclic redundancy checksum
format: hexadecimal
Example Host: CRC
Module: EF12,854E,0F6B
OK
Application PT, FT
Notes
4.4.11.3 Result code Ok: GOK
Syntax Command GOK
Response none
Description Get a result code OK from the module.
Return value(s) none
Example Host: GOK
Module: OK
Application PT, FT
Notes The GOK command is typically used as an alive request. GOK
always returns OK and does not cause any changes to the module
configuration.
4.4.11.4 Exit configuration mode: EXIT
Syntax Command
EXIT
Response none, module performs a reset
Description Leave the configuration mode and enter the data mode. The
entered data sub-mode depends on the setting of the PPR
parameter (see SPPR).
When the command is successful, a reset is performed immediately
and no return code is given by the module.
Return value(s) none
Example Host: EXIT
Module: performs a reset to data mode
Application PT, FT
Notes Parameter changes made by certain configuration commands only
become effective at the exit command. This is described in the
Notes section of the respective commands.