2.0-1
2.0-2
A
B
R
C
D
E
10
- EN
2.0 Accessories Installation
2.1 Installing the Kit: EAA0332G91A
- SLIDING JAW +4 INCH KIT
WARNING
BEFORE INSTALLATION, DISCONNECT THE
TIRE CHANGER FROM THE ELECTRICITY AND
COMPRESSED AIR SUPPLIES.
See
Figure 2.0-1
1) Remove the standard jaws (
R
), present on the tire
changer turntable.
2) Insert the +4” jaws supplied in the kit on the turntable
sliding parts and align the side holes (
A
) with the holes
(
B
) in the sliding parts.
CAUTION: SECURE THE SLIDING PARTS WITH BOTH
SCREWS IN THE HOLES PREPARED.
See
Figure 2.0-2
3) Insert the screws (
C
) in the side holes in the jaws, put
the washers (
D
) on the opposite side and secure with
the nuts (
E
).
NOTE
: If the holes (
B
) in the sliding parts are blocked by
dirt, clean them by MANUALLY inserting an 8 mm diameter
spiral bit in them several times.
CAUTION: AFTER INSTALLATION, THE JAWS MUST
BE EQUIDISTANT FROM THE CENTRE OF THE
TURNTABLE.
Summary of Contents for monty 3550
Page 28: ......
Page 29: ...Mode d emploi Démonte pneus Automatique monty 3550 ...
Page 56: ......
Page 57: ...Manual de Operador Desmontador Automático de Neumáticos monty 3550 ...
