3 of 22
JAN 2022 REV. C
EAZ0080V72A
Jack Beam INSTALLATION AND OPERATION MANUAL
The Jack Beam should only be used with lifts installed on level concrete floors
conforming to the installation instructions for the lift. Consult lift installation instructions
for concrete thickness and strength requirements. Ensure clearance around and above
lift conforms to installation instructions for the lift.
ATTENTION!
This lift is intended for indoor installation only. It is
prohibited to install this product outdoors. Operating environment
temperature range should be 41
– 104 °F (5 – 40 °C). Failure to adhere
will result in decertification, loss of warranty, and possible damage to the
equipment.
Installation of lifts shall be performed in accordance with ANSO/ALI ALIS, Safety
Requirements for Installation and Service of Automotive Lifts
For additional safety instructions regarding lifting, lift types, warning labels, preparing to
lift, vehicle spotting, vehicle lifting, maintaining load stability, emergency procedures,
vehicle lowering, lift limitations, lift maintenance, good shop practices, installation,
operator training and owner/employer responsibilities, please refer to “Lifting It Right”
(ALI/SM) and “Safety Tips” (ALI/ST).
For additional instruction on general requirements for lift operation, please refer to
“Automotive Lift-Safety Requirements for Operation, Inspection and Maintenance”
(ANSI/ALI ALOIM).
NOTE: Air supply must be lubricated and include water separator. Failure to do
so will damage the air /hydraulic motor and void the manufacturer’s warranty.
