12 of 22
JAN 2022 REV. C
EAZ0080V72A
Recommended Maintenance
Daily:
1. Inspect that the Jack Beam is in proper working condition.
2. Make certain that the automatic engaging safety drops into place when the Jack
Beam is raised and that it will release when held in the up position during
lowering.
3. Inspect air/hydraulic system for leaks.
4. Inspect for loose bolts, broken/damaged components. Replace as required.
5. Keep the entire Jack Beam as clean as possible at all times.
6. Ensure that the lifting arm stops are working correctly. Fully extend each arm
until the stop engages.
7. Inspect condition of rubber lifting pads. Replace if required.
Monthly:
1. Keep the air source clean and make certain that an air filter is used to keep dirt out
of the air motor. To maintain a clean shop air supply, an FRL (oil/lube/filter and
regulator) should always be in good working order in conjunction with the use of an
oiler/separator.
NOTE: It is the user(s) responsibility to supply an air filter/lubricator to ensure a
clean air source is provided to the air/hydraulic pump. Failure to provide clean
air may void manufacturers’ warranty.
2. Check functionality of the rollers, keep clean.
3. Grease upper and lower slider block areas. Use multipurpose, extreme pressure
grease such as Megaplex XD5, NGLI grade 2 or equivalent.
4. For best results change hydraulic oil once a year.
ATTENTION!
Discontinue the use of the Jack Beam immediately if any
component (s) are damaged, defective, worn or broken. Please contact
Customer Service 1-800-225-5786.
