HOFFEN VGS-7424, Instruction Manual

Page: 40 / 48

3
40
ATTENTION!
During first use, when the device is heated, allow the steam to be released freely
for several minutes, without directing it at the garments.
ATTENTION!
Make sure there is sufficient space behind the frame with the garment, as
moisture can cause mould to appear.
Make sure that the pockets are empty, unfold any cuffs and pleats.
It is recommended to hang the clothes on hangers, stretch out and straighten
them in order to avoid creases.
Make sure there are no objects behind the ironed clothes that might get damaged
by steam released from the device.
Caution! To use the device, wear the protective glove supplied with the product.
Attachments
a) Brush attachment – suitable for ironing in any operating mode. It is
particularly suited for garments which attract fluff, dust and hair. Press it against
the garment and slowly move the brush up and down on the surface from which
you wish to remove hair.
ATTENTION! For ironing thick fabrics and coats, use the brush attachment.
ATTENTION! Install the attachment when the device has cooled down and is
disconnected from the mains outlet, as per the instructions in 7.4 Attachment
installation/removal.
b)
The pleat clip can be used for ironing in any operating mode. Move the
attachment to within 4 cm from the garment and move it slowly up and down,
ironing out the creases. Repeat this step several times, until the garment is nicely
ironed.
7.6 After using the device
1. After use, turn the dial to the OFF position (device turns off).
2. Place the device on stable and flat surface, in a safe place.
3. Unplug the device from a mains outlet.
4. Pour the remaining water out of the tank, as per the instructions in subsection
7.3 Filling the water tank . Take extra care, as the water in the tank can be
very hot.
5. Wait for the device to cool down and store it in a safe place.