EN
[46]
STEAM IRON
The appliance does
not produce enough
or any steam at all.
The water tank (K) is
empty or does not have
enough water.
Fill the water tank (K).
See the instructions
"Filling up the water
tank”.
The steam control
button (G) is turned off.
Set the steam output
on button (G) according
with the fabrics to iron.
The appliance has not
reached the required
temperature.
Set the temperature
seletor button (G) to the
position marked with
the “MAX” indication and
wait until the appliance
warms up.
No vertical steam
burst output.
You did not wait the
recommended period
of time between each
pressing of the button
(E).
Wait 1 minute between
each pressing of the
button (E) and then
use this function again.
Never repeat this
procedure more than 3
consecutive times.
The steam burst has
been used too often in a
small period of time.
Wait about 1 minute
before using this
function again.
The water spray
does not work.
Not enough pressure or
air inside the water tank
(K).
Press repeatedly the
spray button (D).
The water tank (K) has
no water or has an
insufficient amount of it.
Fill the water tank (K).
See the instructions in
"Filling the water."
Limestone residues
and water drips
come out through
the soleplate’s vents
(L).
Limestone formation
and minerals residues.
Proceed with the self-
cleaning function to
remove lime scale and
minerals accumulated.
See the instructions in
"Cleaning" section.
The appliance has not
warmed up enough.
Set the temperature
seletor button (G) to
the “MAX” position
(maximum) and wait
until the appliance warm
up.
