Step 2
Step 2
12
13
1. Make certain the throttle slider is
in the “off” position. Turn on the
transmitter.
2. Install the fl ight battery in the
fuselage and plug the battery lead
into the lead inside the airplane.
3. Move the stick on the transmitter
(rudder control) side to side while
observing the vertical control surface
is moving per the input (as shown).
Tail Control Test
WARNING: ALWAYS KEEP CLEAR OF THE PRO-
PELLER IN THE EVENT THAT YOU ACCIDENTALLY
TURN ON THE MOTOR!
4. Push the stick full forward (elevator
control). When this is done, the
horizontal control surface should
move down (as shown), causing the
plane to pitch down.
5. Pull back on the stick (elevator
control). When this is done, the
horizontal control surface should
move up (as shown), causing the
plane to pitch up.
Step 7
Step 7
Right
Left
6. If your airplane is not responding,
DO NOT FLY IT! Call the Horizon
Hobby Product Support line at
1-877-504-0233.
7. When you are satisfi ed your airplane
is set up properly, you can unplug
the
fl ight battery and then turn off
the transmitter. This should be done
every time you have fi nished fl ying.
NOTE: It is very important to make
sure that the control surfaces (rudder
and elevator) are at 0 degrees. Ideally,
they will be at 0 degrees when the
levers are centered. The next step ex-
plains how to make adjustments to the
control surface.
Down
Up
