3. The system will display "RX Binding.:'. After successfully binding, the transmitter will
automatically exit this binding menu.
4. If your receiver uses a bind plug for binding make sure you remove it after binding procedure.
NOTICE:
Remove the bind plug to prevent the system from entering bind mode the next time the power is
turned on.
Sometimes servo inputs or ESCs with high input load can cause receiver binding in "No telemetry"
mode. During this binding process you will see both orange and red LED blinking. If you want
to have telemetry function enabled please make sure that nothing is connected to Throttle channel
during binding procedure.
Airplane
Servo setup
Servo setup allows you to adjust Reverse, End points, Subtrim for all 10 channels.
Press and hold the Roller button to main menu and select "Servo Setup".
Press the Roller button to select "Reverse", "End points " and "Subtrim".
Reverse
Main menu
+Servo setup
Dual rate/exp.
Throttle curve
Throttle cut
Mixes
Range test
Servo setup
+Reverse
End points
Subtrim
The Reverse function is used to correct a servo or motor's direction in relation to the system's
controls. For each channel the user can toggle a reverse state based on demand.
This Reverse function individually reverses the direction of operation of servos on the 1 0 channels.
This menu contains 10 check boxes, one of each channel.
Reverse
===Reverse===
Setup:
1. Press the Roller button to select channel .
2. Move the Roller button to left or right to select "Nor" (Normal) and "Rev" (Reverse).
3. Press and hold the Roller button to save and exit , or press the cancel key to exit with out saving.
•••••••••••7x
1a
=
ID CHANNEL TRANSMITTER
6
�
�
'"""'
I
DICITALPRDPDRTIDNAL PRDCRAMMABLE
�I
•--=:: �
"-'
.,. �
�
J
RADIDCDNTADL SYSTEM
��®
Summary of Contents for ORX TX10i
Page 1: ...21cm...
