Elevon:
The elevon function is used for planes that combine the elevons and ailerons together.
Setup:
1 . Use the wheel to enable the elevon function and press the wheel.
2. Use the wheel to set the first channel's position and press the wheel.
3. Use the wheel to set the second channel's position.
4. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
V Tail:
Elevon
+Elevon Off
Chi
so::-;:
Ch2
so::-;:
Chi<= Chi
Ch2 <= Ch2
The V-tail function is used for planes that have no elevators and has a V-tail rudder configuration.
V-tail and Elevon options are mutually exclusive. V-tail is not available if Elevon option is
enabled and vice versa. Elevon option is not available when V-tail option is enabled.
Setup:
1 . Use the wheel to enable the elevon function and press the wheel.
2. Use the wheel to set the third channel's position and press the wheel.
3. Use the wheel to set the fourth channel's position.
4. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
Aileron:
Aileron function supports two options:
IJ tail
+IJ tai 1 Off
Ch2 SO:Y.
Ch-4
so::-;:
Ch2 <= Ch2
Ch-4 <= Ch-4
• Single Aileron - Single aileron output to Aileron channel (Ch2-Ail).
• Dual Aileron - Two outputs (Ch2-Ali and Ch5- Ali2). This allows using a separate servo on each aileron.
In
Single Aileron
function the servo subtrim, reverse and endpoints are done in Servo setup menu.
No additional settings are available.
In
Dual Aileron
servo subtrims, endpoints and reverses are done same way as in Single aileron case.
In addition to this some more functions are available.
User can assign a percentage of each aileron travel (0~100% down and 0~100% up) out of full travel
of the servo set in Servo setup menu. This is useful to compensate differences of each servo travel
and some mechanical imperfections . It is also useful in situations when ailerons should travel down
more than up.
Flaperon
function is also available in Dual Aileron menu. This function enables ailerons to act as flaps
and at the same time ailerons still can function normally controlling the roll of the model. In order to
use Flaperon function:
•••••••••••7x
1a
=
ID CHANNEL TRANSMITTER
18
�
�
'"""'
I
DICITALPRDPDRTIDNALPRDCRAMMABLE
�I
•--=:: �
"-'
.,. �
�
J
RADIDCDNTADLSYSTEM
��®
Summary of Contents for ORX TX10i
Page 1: ...21cm...
