Last updated: 08/13/20108 Rev. 9
1
R7 Build Instructions
1.
I
NTRODUCTION
The R7 is so named as this was the revision the SMW3D/ Hobby-Fab team released; this DIY CNC router
kit. The kit is fully open source. In addition, the kit was released in beta and all feedback taken to
improve build and functionality. Thank you for joining us on this journey. We truly hope this build will
help makers to achieve the satisfaction of creating a machine that will provide years of creativity with
their own two hands.
2.
S
ET
-
UP
We would love for you to rip o
pen this package like it’s Christmas morning and you are eight years old
again. We must warn though, we have individually bagged the steps and they will match the below
inventory as well as the videos on YouTube on the SMW3D/Hobby-Fab page. The videos are labeled
R7v1, this means R7 video one, etc. Please DO NOT open every bag and dump the build on the table.
This will severely impact your build time and locating the proper parts for the steps. The build videos are
very outdated, they should only be used for reference.
We also advise finding a large, clean, flat surface to build your kit. The first few steps can certainly be
performed on a smaller surface however, as the build grows, you will need a four foot by four-foot area
flat surface. It is also advised that you lay out each step individually with all parts for the respective step.
Lastly, before starting the build, please note the BOM (Bill of Materials) is described below and two
columns are present after the item description. Please open each bag prior to build and count each item
and check it off the below list. If anything is missing, please contact us at
.
Performing this task now will prevent having to put off your build in the event we missed something.
Finally, please have fun and take your time. The build process will control all your cuts after, build it
once and build it right. The machine will provide years of great service.
Tools Required: (all should be locally available) Additional Items Required
Metric allen wrench set Bucket for water
Soldering iron and solder Table
Metric tap set Computer
8mm combination wrench USB A to B cable
10mm combination wrench
Square and level
Summary of Contents for R7
