Hobbico Awarf Series, Manual

Page: 26 / 40

Throttle servo linkage
❑
9. Locate the round servo horn and install the
pushrod connector in the hole 3/8" (9.5mm) from the
center of the servo horn following the procedure
described in Step
#
5, engine installation. Slide the
throttle control rod through the pushrod connector.
Gently press the servo horn onto the throttle servo so
that the pushrod connector is positioned at about 40Þ
to the rear of the plane as shown above.
Throttle linkage adjustment
❑
10. Pull on the throttle control rod while viewing
the opening in the top of the carburetor. Leave the
throttle open about 1/16" (1.5mm) and secure the
throttle
pushrod in the pushrod connector. Then cut-
off the excess pushrod 1/4" (6.3mm) past the pushrod
connector.
Full throttle control movement
Idle throttle control movement
The throttle servo
horn should move
40Þto the rear.
For idle speed, move
the throttle stick back
with the throttle trim
forward.
The carburetor
should be completely
open.
The throttle servo
horn should move
forward to about 40Þ.
For full throttle,
move the throttle
stick and trim
forward. If the servo
horn moves in the
wrong direction,
switch the reversing
switch for the throttle
on the
transmitter or
use a reversed
rotation servo.
26
40°
40°
40°