Elevator movement adjustment
or
❑
18. If the elevator moves too far, move the control
rod closer to the center of the servo horn
or
farther
out on the elevator control horn. If the elevator does
not move far enough, move the control rod farther out
on the servo horn or closer to the elevator on the
elevator control horn.
Tape the rudder
❑
19. Use masking tape to hold the rudder in the
neutral position while installing the pushrod and
connecting the servo linkage.
The rudder pushrod
❑
20. Using the illustration as a guide, make a Z-bend
in the threaded rod on the rudder pushrod.
.
Connecting the servo
❑
21. Using the same technique as described in Step
#17 (except use the whole servo horn) connect the
rudder control rod.
Note:
Make sure the steering gear
is straight before marking the control wire. Position
the steering control rod over the rudder servo horn on
the opposite side of the rudder linkage and mark the
rod above the inside hole 3/8" from the center of the
servo horn. Cut the wire 1/4" longer than the mark
and then make a L-bend on the mark. Insert the wire
into the servo horn in the inside hole and place a
retaining clevis on the connection as in previous
steps.
The elevator will
move down as shown
on the control
surface gauge.
30
More control
Less control
More control
Less control
7"
1
1/2"
Summary of Contents for Awarf Series
Page 1: ...Easy as 1 2 3 V1 3 Copyright 1998 ...
Page 40: ......
