Hobart Brothers 6910, Operation And Maintenance Manual With Illustrated Parts List

Page: 65 / 206

(3) Exciter installation
(a) Install exciter in accordance with TM-360.
(b) Reinstall rear frame member and tighten screws securely.
NOTE: It may be necessary to use a large “C” clamp or other arrangement to position frame side rails
and align rear frame member mounting holes.
Removable Rear Frame Cross-Member
Figure 5
D. Engine Control Panel
The engine control panel is designed and mounted in such a manner that it may be released from its
mounted position and tilted outward for access to components mounted on the back side
(see Fig. 6).
Do not disconnect the wires.
(1) Tilt out engine control panel
(a) Remove clamp screw which supports wire conduit above output terminal panel.
(b) Remove four cap screws which attach engine control panel to frame superstructure.
(c) Maneuver panel to tilt it inward at the bottom and outward at the top.
(2) Reinstall engine control panel
(a) Maneuver panel into position and align mounting holes. Install mounting screws and secure.
(b) Secure wire conduit in its original position with clamp and screw.
OM-2028
August 31/90 Revised 2-1
Page 11