HMS PREMIUM ZW1600, Manual Instruction

Page: 23 / 47

HOW TO FILL AND EMPTY THE TANK
1. Remove the fill plug (24) from the upper tank (17).
2. Refer to the A illustration to fill it with water. Insert the funnel (108) into the tank. Use a water cup or
the syphon pump (107) and bucket to fill the tank. Use a water level gauge on the side of the tank to
measure desired water level (volume) in the tank.
3. Refer to the picture B to empty the tank. Place a bucket next to the rower. Use the syphon pump (107)
to pump out the water from the tank into the bucket.
4. Once completed insert the fill plug (24) into the upper tank (17). Wipe excess water out from the
frame after filling.
NOTE:
1. Fill the tank only with muncipal water and don’t use water from a well. If muncipal water is not
available, use distilled water and add water-purification tablet. Never use pool chlorine or chlorine
bleach. More information in the maintenance section.
2. Water from the tank is not suitable for human or animal consumption. Dispose the water after
pumping it out from the tank.
Fig. A Fig. B
WATER LEVEL
1. Look at the fig. A. The water level gauge is situated on the tank side. The max. Filling level is 10. Never
fill it over this limit.
NOTICE:
Not observing it should void the warranty. The standard calibration level is 9.
2. The resistance depends on the water amount in the tank. For exemple, water level 3 offers a light
resistance. Level 9 then means the highest resistance.