HMS PREMIUM ZW1600, Manual Instruction

Page: 22 / 47

ASSEMBLY INSTRUCTION
Step 1: Slide the seat (31) into the rail (3). Insert rear end cap (97) into the rail (3) and secure with two screws
(98).
Step 2 : Secure the two stoppers (13) onto the rail (3) with two bolts (71) and wsahers ø6 (79).
pump (107) Step 3: Attach the rear stand (4) to the rail (3) with four bolts M8*15 (69) and washers ø8 (78).
Step 4:
1. Attach the rail (3) to the main frame (2) with one bolt M6*15 (71) and one barrel nut M10 (28). Lock
the rail (3) in unfolded position using a fixing lever (46) and one washer ø10 (76).
NOTE: After tightening the fixing lever (46), the rear stabilizer of the base frame (1) might be raised off the
floor slightly. It is normal state. It will lean the floor after the user sits on.
Step 5: Insert batteries into the meter (52). Attach the meter post (6) to the main frame (2) using one bolt
M8*130 (64), one washer ø8 (78), one lock washer ø8 (81) and acorn nut M8 (83).
Step 6: Clip the grommet (55) onto both sensor wires (54). Then press the grommet (55) into the left cover
(50). Connect the sensor wire (54) to the connection wire of the meter (52). Push the excess wires back into the
left cover (50).