11 12
13
14
16 15
13
13
14
10
19
20
26
27
11
12
Picture 5
Assembly computer post set (Picture 5)
While a second person holds the Upright (10) near the Frame, connect the Extension wire (26) to
the Rear Switch Wire (20) Next, connect the Resistance Cable (19) to the Lower Resistance Cable
(27) in the following way .
See drawing A. Pull upward on the metal bracket on the lower Resistance Cable (27),and insert
the tip of the Resistance Cable (19) into the wire clip inside the metal bracket .
See drawing B .Firmly pull the Resistance Cable (19) upward and slide it into the top of the metal
bracket.
See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together.
Insert the wires and cables into the Frame.
Tip: Avoid pinching the wires and cables
Slide the upright (10) onto the Frame, Attach the Upright with four M8*20mm Screws (12) and four
M8 Curved washers(11) .
Assembly handle bar set (as picture 6)
Have a second person hold the Handlebar (4) near the Upright (10).Insert the
two Pulse wires (7)into the Upright,and pull them out of the top of the Upright .
Tip:Avoid pinching the pulse wires (7)
Open the indicated clamp on the Upright (10),hold the handle bar (4) inside
the clamp,and close the clamp.Then,slide the handle bar cover (17) onto the
Handle bar and the clamp. Slide the knob Spacer (14), an M8 Split Washer
(15),and an M8 Small Washer (16) onto the handle bar knob (13).
Then tighten the Handlebar Knob into the clamp.
4
13
14
15
16
17
7
Picture 6