HME System 500, Operating Instructions Manual

Page: 16 / 22

14
V. OPTIONAL EQUIPMENT
Equipment Model Number
Headset COMMUNICATOR
®
HS500
Battery for HS500 BAT40
Headset Earmuff No model number
Ceiling Speaker MM100
Ultrasonic Vehicle Detector DU3
Vehicle Detector Board VDB101A
Vehicle Detector Loop (underground) VDL100
Message Repeater MR300
Remote Display R30
Low-Profile Speaker SP2500LP
Microphone DM3
Mode Switch (dual lane) MS1000
Switcher Circuit Board No model number
VI. FCC NOTICE
HME wireless radio frequency systems are type-accepted in the United
States under Part 90 of the Federal Communications Commission (FCC)
Code of Federal Regulations, and type-approved in Canada by Industry
and Science Canada. Because licensing depends on the system’s
application, it is the user’s responsibility to apply for a license
from the FCC in the U.S. and its possessions, or from Industry and
Science Canada in Canada and its territories. Licensing
requirements vary from country to country. Contact your local
licensing agency for specific requirements.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communication. Operation of this equipment in
a residential area is likely to cause harmful interference, in which
case the user will be required to correct the interference at his
own expense.
Changes or modifications not expressly approved by HM Electronics,
Inc. could void the users authority to operate this equipment.