29
Routine Operation
Power On/Off
•
To turn WS200 power on
, press and release the
POWER
button.
—
Red lights will go on over the
POWER
,
ISO
and
IC
buttons.
—
If listening with a headset, or the speaker is turned on, you will hear “Power on, Speaker #, Version #.”
—
The light over the
ISO
button will go off.
—
The light over the
IC
button will change to green.
•
To turn WS200 power off
, press and hold the
POWER
button for 3 seconds.
ISO and IC
The
ISO
,
IC1
or
IC2
buttons can be used to talk to other COMMUNICATOR
®
s.
IC
will send the audio signal
out to intercoms through the
HEADSET
and
4-WIRE
connections on the rear panel of the Base Station.
Depending on your Base Station
RELAY
connection setup (See page 22), either the
ISO
button or the
IC
button
will activate any outside equipment connected to the
RELAY
connector on the rear panel of the Base Station.
Push-To-Talk Mode
•
Press and hold the
ISO
or
IC
button while speaking.
—
The green light over the button will be flashing when the unit is transmitting.
•
Release button to listen on headset speaker or internal speaker, if “
ON
.”
—
The green light over the button will be on steady.
•
Adjust volume level with
VOLUME
up
▲
and down
▼
buttons if necessary.
Hands-Free Mode
You must be using a headset plugged into the Speaker Station, and the speaker must be off for hands-free operation.
•
Quickly press and release the
ISO
or
IC
button.
—
The green light over the button will be flashing.
•
Speak and listen as in a normal telephone conversation.
•
Adjust volume level with the
VOLUME
up
▲
and down
▼
buttons if necessary.
•
Press and release the
ISO
or
IC
button again to end communication.
—
The green light over the
IC
button will be on steady.
•
Press and release the
ISO
or
IC
button if you want to speak again.
—
The green light over the button will begin flashing again.
•
Pressing and holding the
ISO
or
IC
button for more than a half second will result in PTT operation.
ISO Lockout Mode
To set the Speaker Station with the ISO feature locked out, with the power off, press and hold the
IC
button
while you press and release the
POWER
button. You will hear “Power on, Speaker #, Version #, ISO off.”
When set up for the ISO Lockout mode, the
ISO
button will operate the same as the
IC
button, in either
hands-free or PTT communication.
To reset the ISO feature for normal
ISO
button communication, with the power off, press and hold the
ISO
and
IC
buttons while you press and release the
POWER
button. You will hear “Power on, Speaker #,
Version #, ISO on.”
