13
o
4 6
BELTPAC / ALL-IN-ONE HEADSET / SPEAKER STATION
SETUP AND REGISTRATION
The first time you operate the DX121 system, you must register each BP200 Beltpac, WH200 All-In-One
Headset and/or WS200 Speaker Station COMMUNICATOR
®
for use with a specific Base Station. The Base
Station will then recognize all registered Communicators when their power is on, and will know the difference
between them and other electronic equipment operating on the same frequencies. If a Communicator is added,
replaced or repaired later, the new one must be registered and the old one remains in memory. A maximum of 4
Communicators can be registered to a single Base Station at one time. If the maximum number of 4 is
exceeded, you must clear all current registrations and re-register all active Communicators.
NOTE:
The following two pages are for Beltpac setup and registration. All-In-One Headset setup and
registration instructions are on pages 15 and 16. Instructions for Speaker Station setup and
registration are on pages 17 - 20.
Set Up Beltpacs
Before registering them, set up all Beltpacs as follows.
Step 1.
Insert a fully charged battery in the
Beltpac, with the metal contacts on
the end of the battery inserted first.
Press it in until it snaps.
Step 2.
Place the Beltpac in the pouch.
Step 3.
Plug the headset cable connector into the Beltpac.
Register Beltpacs
Beltpacs must be within 6 feet (1.83 meters) of the Base Station while you are registering them. Be certain the
Base Station power is on, and each Beltpac you are going to register is turned off before you begin. Beltpacs
that are already registered can be on or off.
NOTE:
If you are setting up multiple Base Stations, the following steps must be repeated for Beltpacs being
registered to each Base Station.
Step 1.
Put the headset, of the Beltpac being registered, on your head.
Step 2.
Press the
REG
button on the front panel of the Base Station
(#
6
on Base Station front panel illustration).
•
The
STATUS
display (#
4
on Base Station front panel
illustration) will show a small “
o
” for open.
NOTE:
If you wait too long before going on to Step 3,
the Base Station will go out of the registration
mode and you will have to repeat Step 2.
Step 3.
Press and hold the
ISO
button on the Beltpac while you press and
release the
PWR
(power) button to turn the unit on, then release the
ISO
button. This will cause the Beltpac to enter the registration mode.
•
The two power lights at the corners of the Beltpac near the
IC
and
ISO
buttons will begin blinking red, then will blink green
two or three times and go off.
•
Wait!
There may be a short delay.
Step 2
Step 1
Step 3
