5)
Filling up the water tank
Remove the water tank and fill it with pure, cold water up to the mark on the upper edge of the tank.
Then push the water tank back into the base untis as far as it will go.
è
If the pilot lamp on the water tank lights up in blue, there is enough water in the tank
è
If the pilot lamp on the water tank lights up in red, there is not enough water in the tank
6)
Switching on the appliance
Press ON/Standby button for about 2 seconds to switch the appliance on.
NOTE: if no further button is pressed within 2 minutes, the appliance switches
back to standby mode.
The integrated scaled determine the total weight of the appliance.
A rotating bar lights up in the display.
NOTE: Do not move the appliance during weighing.
After the check, the appliance turns into operating mode.
è
All available programs are shown at the display
è
Additionally the display shows a flashing “0”
7)
Taring the scales
IMPORTANT: Before you tare the scales to zero position, make sure that:
-
The appliance is properly assembled
-
The selected pasta form is inserted
-
The water tank is filled up completely to the mark
-
There is no flour inside of the kneading container yet
Press the SCALES button to tare the scales.
NOTE: if you change the weight of the appliance after taring the scales, a re-taring is necessary.
NOTE: do not move the appliance during weighing!
Summary of Contents for homy90
Page 117: ......
