Hiwin LMSSA, Assembly Instructions Manual

Page: 20 / 44

Contents
Linear motor axis LMSSA LMSSA-01-1-EN-2201-MA Seite 20 von 44
5 Assembly and connection
Danger! Danger from electrical voltage!
Before and during assembly, disassembly and repair work, dangerous currents may flow.

Work may only be carried out by a qualified electrician and with the power supply disconnected!

Before carrying out work on the linear motor system, disconnect the power supply and protect it from being
switched back on!
Danger! Risk of crushing from strong forces of attraction!
There is a risk of crushing from the strong forces of attraction emitted by the stators, as they are assembled
with opposing polarity!

Assemble the stators carefully!

Do not place fingers or objects between the stators!
Warning! Risk of crushing from forcer housing!
Danger of injury from crushing and damage to the linear motor system caused by movement of the forcer
housing due to gravity, as it does not feature brakes in its standard version.

Ensure that the linear motor system does not exceed 1° horizontal deviation!
Warning! Risk of crushing from the forcer!
Danger of injury from crushing and damage to the forcer through uncontrolled movements during assembly.

Ensure that the forcer is locked in place during assembly using transportation safety devices!
Warning! Risk of crushing from strong forces of attraction!
Danger of injury from crushing and damage to the forcer or stator caused by very strong forces of attraction.

Ensure that the forcer only comes close to the stator when the linear guideways can absorb the forces!
Warning! Danger from heavy loads!
Lifting heavy loads may damage your health.

Use a hoist of an appropriate size when positioning heavy loads which are over 20 kg!

Observe applicable occupational health and safety regulations when handling suspended loads!

To transport the linear axis, hoist it at the points designated A and B (see Section 4.2)!
Attention! Damage of the linear motor system!
The linear motor system may be damaged by mechanical loading.

No heavy load on the cover!

No moving the forcer housing!
Note:
The mounting surface must have a flatness of 0.03 mm over 300 mm.
Note:
The linear motor system may only be assembled by specialist personnel.