2 Features and benefits
TCGB0070 rev.3 - 04/2012
26
New wall support (Factory supplied)
A new wall support has been designed to allow an easy installation work by following these steps:
•
Step
: The wall support must be fixed on the wall using appropriate plugs and screws.
•
Step
: The unit should be placed on the wall hanging it on the wall support.
•
Step
: The unit installation should be finished fixing it at the bottom side using appropriate plugs and screws. To do
so, the unit is equipped with two holes at the bottom outer edges of back plate frame (there are two additional holes
on the upper outer edges of the back plate frame in cases where the wall support could not be installed).
N O T E
For more information, please refer to the Service Manual (SMXX0070).
Easy cabinet assembling
The design of the new cabinet enables a better assembling by following these steps:
•
Step
: Place the unit’s cover at same level of the wall mounted unit by taking it from the bottom side.
•
Step
: Put the right side cover holes into the back plate frame hooks (x2 locations) by the help of the external marks
indicated by “ >”.
•
Step
: When the right side is centered, repeat the operation on the left side.
•
Step
: Once the 4 hooks are placed into its corresponding cover holes, move down the cover until the end of the
hooks.
•
Step
: For the final fixation of the cover, open the LCD user’s interface service cover and screw the two screws
fixing with the nylon washers.
•
Step
: Finally, close the LCD user’s interface service cover.
N O T E
For more information, please refer to Service Manual (SMXX0070).
