5
/
12
2. Installation of the Biometric Reader
2.1 Place the Biometric Reader
Install the Biometric Reader on a horizontal and stable place. No light through a window or
from lamps should enter the scanning area of the Biometric Reader.
It is recommended that you use the Biometric Reader in the 300-1000 lx luminance
environment, which is equivalent to brightness suitable for reading a newspaper.
Important
Do not use the Biometric Reader in places where the Biometric Reader is exposed
to the strong light such as outdoors, near windows, near a light source. It may lead
to an authentication failure.
2.2 Connect the USB cable
Connect the USB Micro-B plug of the USB cable to the USB Micro-B connector of the
Biometric Reader.
Connect the plug A of the USB cable to the USB port of your PC.
Attention
Connect the USB plug and the USB connector securely. Hold the plug end when
connecting or disconnecting the USB cable to prevent the connectors from
breaking down.
Important
When connecting the USB cable via a USB hub, check the supply current. The
Biometric Reader may malfunction with insufficient power supply.
Biometric Reader may hold some heat due to the use of infra-red rays inside, but
this will not cause malfunctions.
Do not connect more than two Biometric Readers simultaneously to one PC. If
multiple Biometric Readers are connected, they will not work properly.
After connecting the Biometric Reader to your PC, wait for at least 5 seconds
before performing any operation.
Biometric Reader
USB Micro-B connector
USB Micro-B plug
USB cable
