-11-
5. Removal of the switch and the controller
(1) After removal of Housing (A)
[28]
, pull out the receptacle of the Brush Block
[27]
from the Pushing
Button Switch
[36]
. Remove the Pushing Button Switch
[36]
from Housing (A)
[28]
.
(2) Remove the terminal screw of the Pushing Button Switch
[36]
and remove the terminal of the Controller
Terminal Set
[37]
. Remove the Pushing Button Switch
[36]
and the Controller Terminal Set
[37]
from
Housing (A)
[28]
.
6. Removal of the slide knob and the slide bar
(1) After removal of the Armature and Pinion Set
[4]
, Magnet
[5]
, Brush Block
[27]
and Pushing Button
Switch
[36]
, push the Slide Bar
[33]
forward while pressing the Slide Knob
[34]
against the rear of the
main body. Then the Slide Knob
[34]
and the Slide Bar
[33]
can be removed.
Reassembly can be accomplished by following the disassembly procedure in reverse. However, special
attention should be given to the following items.
1. Mounting the armature and pinion set, magnet and brush block
(1) When mounting the Magnet
[5]
, arrange the Magnet
[5]
so that the flanged side of the yoke is
positioned at the rear of the main body and fit the stop rib of Housing (A)
[28]
in the stop groove of the
Magnet
[5]
.
(2) Mount the Brush Block
[27]
aligning with the fixed rib of Housing (A)
[28]
. Push the internal wire of the
Brush Block
[27]
in the central groove of Housing (A)
[28]
completely for prevention of pinching.
(3) When inserting the Armature and Pinion Set
[4]
into the Magnet
[5]
and the Brush Block
[27]
, each part
is raised. Check the above (1) and (2) again after mounting the Armature and Pinion Set
[4]
.
(4) After mounting the Armature and Pinion Set
[4]
, be sure to mount the Rubber Bushing
[6]
to the ball
bearing of the Armature and Pinion Set
[4]
.
2. Mounting the switch and the controller
(1) Mount the Pushing Button Switch
[36]
so that the tip of the pushing button securely contacts the
pushing button groove of the Slide Bar
[33]
after connection of each internal wire.
(2) When mounting the Controller Terminal Set
[37]
, align with the fixed rib of Housing (A)
[28]
being
careful of the mounting direction of the battery terminal and the remaining power indicator. Push the
internal wire of the Controller Terminal Set
[37]
in the internal wire groove of Housing (A)
[28]
completely for prevention of pinching.
Reassembly
