-17-
Fig. 12
Fig. 13
(7) Reassembly of the housing
(a) Mount the LED to housing (A) of Housing (A).(B) Set
[31]
without twisting the LED internal wire attached
to the DC-Speed Control Switch
[35]
. Put the LED connected with the internal wire (red) in the space
provided on the DC-Speed Control Switch
[35]
side and the LED connected with the internal wire (blue)
in the space provided on the upper side of Housing (A).(B) Set
[31]
. Mount these two LEDs positioning
the chamfered side as shown in Fig. 12.
(b) Mount the assembly of the Motor
[30]
and the Gear Box Ass’y
[1]
to housing (A) of Housing (A).(B) Set
[31]
. At this time, fit the protrusions of the Gear Case
[12]
and the Motor Spacer
[29]
in the concave
portions of Housing (A).(B) Set
[31]
and the protrusion of the Clutch Dial
[6]
in the concave portion of
Housing (A).(B) Set
[31]
. Align the two Needles
[13]
protruded from the Gear Case
[12]
with the two
holes of Housing (A).(B) Set
[31]
. Be careful not to pinch the internal wires of the LED (Fig. 13).
Internal wire (blue)
Space for the LED
Housing (A).(B) Set
[31]
LED light
Chamfered side
LED
Chamfered side
LED
Internal wire (red)
A-A
B-B
Clutch Dial
[6]
mounting position
Gear Case
[12]
mounting position
Needle
[13]
mounting position
Motor Spacer
[29]
mounting position
