-19-
Push down.
J295 jig (B)
for retaining ring
J295 jig (A)
for retaining ring
Retaining Ring
[2]
Washer (D)
[3]
(8) Mounting Guide Sleeve (A) [5]
Put the Steel Ball D3.5 (10 pcs.)
[11]
in the hole of
the socket. Mount Guide Sleeve (A)
[5]
, Guide
Spring
[4]
and Washer (D)
[3]
in sequence. Fit the
Retaining Ring
[2]
in the groove of the socket using
the J295 jigs (A) and (B) for retaining ring as
illustrated in Fig. 16.
NOTE: Be sure to replace the Retaining Ring [2]
with new one because the Retaining
Ring [2] may be deformed if it is
removed. Guide Sleeve (A) [5] may come
off if the deformed Retaining Ring [2] is
used again.
(9) Other precautions in reassembly
After completion of reassembly, set the storage battery and check for operation.
(a) Checking the rotating direction of Guide Sleeve (A)
[5]
Press the (R) side of Pushing Button (A)
[34]
to check that Guide Sleeve (A)
[5]
rotates clockwise as
viewed from behind. (If Guide Sleeve (A)
[5]
rotates counterclockwise, the internal wires of the Motor
[30]
and the DC-Speed Control Switch
[35]
are soldered in reverse.)
(b) Checking the LED
Turn on and off the trigger switch of the DC-Speed Control Switch
[35]
to check that the LED lights and
goes out. (When turning on the trigger switch, the LED lights. When turning off the trigger switch, the
LED goes out.)
(10) Screw tightening torque
Tapping Screw (W/Flange) D3 x 16 (Black)
[36]---------------
1.1 - 1.9 N·m {11 - 19 kgf·cm}
2. Precautions in disassembly and reassembly of battery charger
Please refer to the Technical Data and Service Manual for precautions in disassembly and reassembly of
the Battery Charger Model UC 10SFL.
Fig. 16
