-11-
Fig. 1-1 Hold the body and adjust the gap of the
Retaining Ring
[2]
to the groove of socket, then insert a
small flat-blade screwdriver into the groove at an angle.
Guide Sleeve (A)
[5]
Socket
Retaining Ring
[2]
Small flat-blade
screwdriver
Washer (D)
[3]
Fig. 1
(4) Disassembly of the power supply unit
Unsolder the Internal Wire (Black)
[32]
and the Internal Wire (Red)
[33]
of the Motor
[30]
with a soldering
iron and disconnect them from the Motor
[30]
. Disconnect the Internal Wire (Black)
[32]
and the Internal
Wire (Red)
[33]
of the Motor
[30]
from the DC-Speed Control Switch
[35]
with a soldering iron in the same
manner.
The internal wires of the DC-Speed Control Switch
[35]
(two LEDs are connected with the internal wires)
and the Controller (B)
[39]
are soldered to each terminal.
Unsolder the internal wire (red) ((B+) terminal side of the DC-Speed Control Switch
[35]
), internal wire
(white) ((B-) terminal side of the DC-Speed Control Switch
[35]
) and internal wire (blue) of the DC-Speed
Control Switch
[35]
with a soldering iron and disconnect them from the DC-Speed Control Switch
[35]
.
Before unsoldering the internal wire (blue), be sure to remove the heat shrinkable tube.
NOTE: Do not remove the DC-Speed Control Switch [35] and the Controller (B) [39].
Fig. 1-2 Press down Washer (D)
[3]
with the small
flat-blade screwdriver.
Fig. 1-3 Slide the small flat-blade screwdriver under
one side of the gap of the Retaining Ring
[2]
.
Fig. 1-4 Slowly raise the Retaining Ring
[2]
using the
end face of Guide Sleeve (A)
[5]
as a fulcrum.