English
25
21. Do not leave the tool running unattended on the
fl
oor, table or
other locations. Doing so may result in injury.
22. When attaching application tools, be careful not to get your
fi
ngers or other extremities caught in the lever.
23. If the application tool seems to be loose or uneven after attaching
it to the unit, re-attach the tool. Operating the unit with a loose or
uneven application tool may result in injury.
24. When switching on the tool, make sure the application tool is not
in contact with any processing materials. Failure to do so may
result in injury.
25. For cutting e
ffi
ciency, switch the mode of the application tool
according to task conditions and materials to be cut.
26. After use, be sure not to place the tool near chips or sawdust
before it comes to a full stop as the tool may suck in those
particles.
27. Do not polish wood with sanding paper used for metal polishing.
28. Do not use worn or clogged sanding paper.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the
protection function to stop the output.
In the cases of 1 to 3 described below, when using this product, even if
you are pulling the switch, the motor may stop. This is not the trouble
but the result of protection function.
1. When the battery power remaining runs out, the motor stops.
In such a case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this case, release
the switch of tool and eliminate causes of overloading. After that,
you can use it again.
3. If the battery is overheated under overload work, the battery
power may stop.
In this case, stop using the battery and let the battery cool. After
that, you can use it again.
Furthermore, please heed the following warning and caution.
WARNING
In order to prevent any battery leakage, heat generation, smoke
emission, explosion and ignition beforehand, please be sure to heed
the following precautions.
1. Make sure that swarf and dust do not collect on the battery.
○
During work make sure that swarf and dust do not fall on the
battery.
○
Make sure that any swarf and dust falling on the power tool during
work do not collect on the battery.
○
Do not store an unused battery in a location exposed to swarf and
dust.
000Book̲CV14DBL̲ChS.indb 25
000Book̲CV14DBL̲ChS.indb 25
2017/04/17 16:38:11
2017/04/17 16:38:11
