You can configure and control the projector via the network using commands.
Communication Port
The following two ports are assigned for the command control.
TCP #23
TCP #9715
Command Control Settings
(
25
)
Configure the following items from a web browser when command control is used.
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter
[http://192.168.1.10/]
into the address bar of the web browser.
2) Enter the Administrator ID and Password and click
[Logon]
.
3) Click
[Port Settings]
on the main menu.
4. Utilize projector – Advanced -
4.8 Command Control via the Network
4) Click the
[Enable]
check box to open
[Network Control Port1 (Port: 23)]
to
use TCP #23. Click the
[Enable]
check box for the
[Authentication]
setting
when authentication is required, otherwise clear the check box.
5) Click the
[Enable]
check box to open
[Network Control Port2 (Port: 9715)]
to
use TCP #9715. Click the
[Enable]
check box for the
[Authentication]
setting
when authentication is required, otherwise clear the check box.
6) Click the
[Apply]
button to save the settings.