Hitachi CP-S335W, Service Manual

Page: 39 / 75

38
CP-S335(C9SM)/CP-X340, PJ552 (C9X)/CP-X345, PJ562 (C9XM)
Notice
(2) Take the Power Center Sheet and the Power
Side Sheet off.
Next, get POWER BOARD(CIRCUIT) off as
unclipping three holders and a POWER-
BRACKET hook.
NOTE:
In removing POWER BOARD(CIRCUIT), use
flat screw driver or fine tool to unclip the holder
with the arrow shown below.
1. Attaches UPPER CASE assembly
The screw hole (a4) is weaker than the others
(a1),(a2) and (a3).
Tighten this screw carefully in accordance with
screw torque below.
Screw torque : 0.6 to 0.9Nm(6 to 9kgm)
2. Removes POWER BOARD(CIRCUIT)
(1) Unscrew two screws and remove a plastic rivet,
and then get the BALLAST-BRACKET off.
screw
BALLAST-BRACKET
plastic rivet
screw
POWER-BRACKET
hook
Power Side Sheet
Power Center Sheet
holder
POWER-BRACKET
holder
holder
POWER BOARD
(CIRCUIT)
(a3) (a2) (a1)
(a4)
Bottom of the projector