Hitachi 51F510, Manual

Page: 134 / 152

DP-4X CHASSIS MAGIC FOCUS “PATTERN SET UP”
PAGE 08-2
7
IMPORTANT:
Remote MUST BE IN Digital
Convergence Adjustment Mode .
To enter the Remote Control
into DCAM see page 08-18.
NOTE: This instruction should be
applied when a new DCU is being
replaced or your having trouble
with Magic Focus Initialization.
NOTE: This instruction shows how
to set up the pattern position for
Magic Focus. Each model has a
specific set up pattern position.
Adjustment Preparation:
•
Receive NTSC RF or Video
Signal.
•
With Power Off, Press and
HOLD the SERVICE ONLY
SWITCH on the Deflection /
Convergence PWB, then press
the Power On/Off at the same
time, until picture appears, then
release both. (Picture may be
displayed without convergence
correction data. Press the
Service Only button to bring
up Internal Crosshatch.)
Adjustment Procedure:
1) Press the PLAY key on
either R/C. (One additional line
appears near the top and
bottom.
2) Press the CC Key on CLU-
3842WL or Fast Forward
Key on the CLU-4341UG2
The PATTERN mode is displayed
as follows.
RH : 04
RV : FF
0 1 2
6 5 4
7 3
DP-4X New Remote Controls. (CLU-3842WL or CLU-4341UG2) The Remotes must be placed into
*DCAM (See Instruction Page) before using them for Digital Convergence adjustments.
*
DCAM = Digital Convergence Adjustment Mode.
* The new DP-4X Remote Controls do not have these buttons. Technician must use Remote Control
from the DP-3X family group.
0
1
2
3
4
5
6
7
RH 4 0 FC 2 FC 0 4 FE
RV
FF
FE
1
0
FE
1
0
0
GH
4
0
FC
2
FC
0
4
FE
GV FF FE FF 0 FF 1 0 0
BH 4 0 FC 2 FC 0 4 FE
BV
FF
FE
FF
0
0
1
FF
0
NORMAL MODE: 51 , 57 and 65 INCH SETS
3) Use the 6 Key to rotate
Arrow. Arrow rotates clock-
wise with each press on the 6
Key.
4) Use the following Keys to
switch color of patterns.
•
INFO : GREEN Select
•
0 : RED Select
•
INPUTS
: BLUE Select
5) Press the Thumb stick Left
and Right buttons to change
the Pattern Position Data in
horizontal Direction.
Press the Thumb stick Up and
Down buttons to change the
Pattern Position Data in
Vertical Direction.
6) Set the Data Values as shown
in the Table below.