Hisun HS700UTV-4, Maintenance Handbook

Page: 113 / 388

MAINTENANCE AND ADJUSTMENT OF THE UTV
- 100-
NOTE
:
The specified amount of coolant is a standard
amount. Fill the cooling system with coolant
until coolant comes out of the hole for the air
bleed bolt.
Coolant is potentially harmful and should be
handled with special care.
WARNING :
· If coolant splashes in your eyes, thoroughly
wash them with water and consult a doctor.
· If coolant splashes on your clothes, quickly
wash it away with water and then with soap
and water.
· If coolant is swallowed, induce vomiting and
get immediate medical attention.
· If coolant comes into contact with painte d
surfaces, immediately wash them wit h
water.
· Do not mix different types of antifreeze.
NOTE
:
Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check, and if
necessary, correct the antifreeze
concentration of the coolant. Use only
distilled water. However, soft water may be
used if distilled water is not available.
14. Install:
·
air bleed bolt
9 Nm (0.9 m · kg, 6.5 ft · lb)
·
radiator cap
·
Fill coolant reservoir:
(with the recommended coolant to the
maximum level mark
○
a
)
·
Install coolant reservoir cap:
·
Start the engine, warm it up for several
minutes, and then turn it off.
·
Check: