Hisun 450ATV-2, Maintenance Manual

Page: 90 / 115

90
the Shaft Arm where the worn out must be replaced.
3、Inspection of Rear Suspension:
Identical inspection process with Front Suspension (Ref:
Page 119)
4.6.2.3 Assembly of Rear Suspension:
1、Clean Needle Bearing and its Inner Liner Pipe with soft
cloth, grease Needle Bearing with Lithium Lubrication
and place the Inner Liner Pipe into Needle Bearing.
2、Clean the three Needle Bearings and Liner Pipe of Rear
Suspension Shaft Arm with soft cloth, grease Needle
Bearing with Lithium Lubrication and place Liner Pipe
into Needle Bearings.
3、Mount Pan Fork onto the Frame with Pan Fork Shaft.
4、Use Special Pin and Cotter Pin to have Rear Suspension
and Shaft Arm connected.
5、Use M12 Bolt to connect Shaft Arm with the Frame and
Pan Fork.
6、Use M12 Bolt to mount the upper end of Rear Suspension
onto the frame and lower end onto Shaft Arm.
7、Mount Rear Bridge onto Rear Suspension (Ref. Page 108)
4.7 Cooling System of Engine
4.7.1 Disassembly, Inspection and Assembly of Water Cool