Hisun Motors VECTOR 500, Owner'S Manual, Page: 39 / 67

PERIODIC SERVICE 11-4
2. Check to see that the coolant level is between
the “FULL” and” LOW” marks of recovery tank.
3. When the coolant level drops due to
evaporation, add water only up to the full level.
In case of leakage add anti-freeze and water
in the specified mixing ratio up to the full
level.(see flush cooling system and changing
coolant in EVERY 2 YEARS in PERIODIC
SERVICE section)
①
Recovery tank
②
FULL
③
LOW
IMPORTANT

If the radiator cap has to be removed, follow
the cautions above and securely retighten the
cap.

Use clean fresh water and anti-freeze to fill the
recovery tank.

If water should leak, consult your local HSUN
Dealer.
■
Cleaning radiator screen
CAUTION
TO avoid personal injury:

Be sure to stop the engine before removing
the screen
1. Park the vehicle on a flat surface,
2. Remove the radiator cover,
3. Detach the screen and remove all foreign
materials,
①
Radiator screen
IMPORTANT

Radiator screen must be clean from debris to
prevent engine from overheating
■
Checking brake fluid level
CAUTION
TO avoid personal injury:

Never operate the vehicle if the brake fluid
is below the minimum mark.

Use only DOT3 from a sealed container.
Other type of oil may ruin synthetic resin
or rubber installed in brake system
components and may cause brake failure.

Avoid clean contamination of the brake
fluid thoroughly before removing the filler
cap. Do not open the brake fluid reservoir
cap unless absolutely necessary.

Use extreme care when filling the reservoir.
If brake fluid spills on the power steering
hose, wash off with water immediately, as
brake fluid quickly ruins synthetic resin or
rubber hoses.
1. Park the vehicle on a level ground and open
the hood.
2. Check to see that the brake fluid level is the
LOWER mark.
3. If
it is below the “LOWER” mark add brake
fluid .