16
Electrical Connections
Before connecting the power supply, please confirm the
unit suits the power supply.
Breaker protection must be installed according to
the max value stated in the nameplate attached to
the unit inside of the front panel.
The equipment must be installed via an isolator
switch with a minimum breaking gap of 3 mm
．
The power supply must conform to the specification
on the unit’s nameplate. The supply voltage must
be within the range specified in the electrical data
table. For wiring connection, refer to the electric
wiring diagram on the inside panel of the unit.
When the building is equipped with a RCD the heat
pump should be equipped with a separate one
．
IMPORTANT:
During the installation of the unit, first make the
water connections and then electrical connections.
If the unit is to be removed first disconnect the
electrical connections, then the water connections to
reduce the chance of an electrical shock.
WARNING:
Disconnect the main power supply switch before
servicing the system or handling any internal parts
of the unit.
In case of any major malfunction turn the unit off,
disconnect the mains power supply and contact a
qualified service engineer.
Power Connection
